Installation
Instructions:
1) Determine the center of the window horizontally and vertically
and mark with a pencil. It is best to mark the window frame and the
side of the RV 2 to 3 inches from the window frame.
2) Determine the center of the Window Cover horizontally and vertically and
mark
lightly with a pencil. If the measurements are correct, the marks on the side
of the RV and the Window
Cover should match when the cover is held up to the window. If not remeasure.
3) Place the Window Cover so it lines up with the marks on the RV and determine
which corner you want to install first and mark where to drill for the first
fastener. Then after rechecking
your alignment install the fastener. Please Note: If your cover has a fastener
in the center of the
top it is usually best to start with it and then work out to the corners.
4) Do the same process for the rest of the corners. Use an eraser to remove pencil
marks.
Always pull the fabric snug to remove any wrinkles. If you take your time you
should end up with a professional looking installation.
|
